The short answer
You likely need a new AC if your system can't keep up on hot days, needs frequent major repairs, or your home has no central cooling at all. Before recommending anything, we check your home's cooling load, ducts and electrical service, then give you written options for central AC, a heat pump, or a ductless system, with cost based on your home rather than a one-size-fits-all number.
Installing a new air conditioner is a big decision, and in Los Angeles the right system depends a lot on where you live. A home in the San Fernando Valley faces very different summer heat than a house a few miles from the coast. Royal HVAC Solutions installs central air conditioners, heat pumps and ductless systems for homeowners in Los Angeles and nearby cities. This page covers when replacement makes sense, what we look at before recommending a system, your options, what drives the cost, and how an installation visit works from start to finish.
Signs It May Be Time for a New Air Conditioner
Not every problem means you need a new system. But some patterns suggest your current unit is near the end of its useful life, or was never a good fit for your home.
Los Angeles has dry summers and mild winters, but inland neighborhoods and valleys run much hotter in summer than areas near the coast, and fall Santa Ana winds can bring hot, dry spells late in the season. A system that kept up fine in a home near the beach may be undersized for a house in the valleys. If any of these signs sound familiar, an assessment can tell you whether repair or replacement makes more sense.
- The system runs constantly on hot afternoons and still can't bring the house down to the set temperature.
- Repairs keep coming back, especially for major parts like the compressor or outdoor coil.
- Your electric bills climb summer after summer without any change in how you use the AC.
- Some rooms stay hot while others get cold, even with every vent open.
- The unit uses an older refrigerant that is getting harder and more costly to service.
- You have no central air and rely on window units or fans during heat waves and Santa Ana wind events.
- You're adding square footage, converting a garage, or finishing an attic.
What We Check Before Recommending a System
A good installation starts with an accurate picture of your home. Choosing a new unit based only on the size of the old one can repeat old mistakes. During the assessment, our technician looks at:
We also ask how you use your home. Whether someone works from home, which rooms feel uncomfortable, and whether anyone in the house is sensitive to dust or allergens all shape what we recommend.
- Cooling load: square footage, ceiling height, insulation, window size and direction, and how much afternoon sun the home gets.
- Ductwork: leaks, crushed or disconnected runs, poorly insulated sections in the attic, and whether duct sizes match the airflow a new system needs.
- Electrical service: whether your panel and wiring can support the new equipment, especially if you're moving to a heat pump.
- Outdoor unit location: clearance, noise near bedrooms or neighbors, drainage, and access for future service.
- Indoor equipment: the condition of your furnace or air handler, since it has to work properly with the new outdoor unit.
- Thermostat and controls: compatibility with the new system and whether zoning would help with uneven temperatures.
Repair, Replace, or Upgrade: Your Options
If the assessment shows your current system is basically sound, a repair may be the sensible choice, and we'll tell you so. When replacement does make sense, you usually have a few paths:
Heat pumps deserve a close look in Los Angeles. Our mild winters suit them well, and they can simplify things if your gas furnace is also aging. South Coast AQMD Rule 1111 limits NOx emissions from natural-gas central furnaces sold and installed in the region, and the district has been amending it toward zero-emission requirements. If you're planning to replace a furnace soon, check the current rule, because the district sets and revises the compliance dates.
If you're an LADWP residential electric customer, you may be able to apply for a Consumer Rebate Program rebate on a qualifying heat pump system. The amount depends on the unit's SEER2 and HSPF2 ratings, and you apply after the equipment is purchased and installed, within 12 months of purchase. Many homes outside the City of Los Angeles are served by Southern California Edison instead, so the rebates available depend on the utility that serves your address. We confirm the current offer before including it in a quote. Keep in mind that the federal Energy Efficient Home Improvement Credit only covered qualifying heat pumps placed in service before December 31, 2025, so it doesn't apply to new installations now.
- Central AC replacement: a new outdoor condenser and matched indoor coil, connected to your existing furnace and ducts.
- Heat pump system: one system that both cools and heats, replacing a separate air conditioner and gas furnace.
- Ductless mini-split: individual indoor units for homes without ducts, additions, or rooms the main system doesn't reach well.
- Duct repair or replacement alongside new equipment, when the existing ducts would hold back the new system's performance.
What Affects the Cost of AC Installation
Every quote is built around your home, so the price varies from house to house. The main factors are:
We put these items in writing so you can see what you're paying for and compare options side by side. Where a rebate may apply, we'll explain the eligibility requirements, but we won't count on it until it's confirmed for your address.
- System type: central AC, heat pump, or ductless.
- Capacity: the cooling size your home actually needs.
- Efficiency rating: higher-SEER2 units cost more upfront but use less electricity to run.
- Ductwork condition and how much needs sealing, repair, or replacement.
- Electrical upgrades, such as panel work or a new dedicated circuit.
- Installation access: tight attics, crawlspaces, rooftop units, or long refrigerant line runs.
- The number of zones or indoor units for ductless systems.
- Thermostat choice and add-ons such as upgraded air filtration.
How an Installation Visit Works
Assessment. A technician visits, inspects your current equipment, ducts and electrical service, and talks through your comfort goals. You get written options instead of a single take-it-or-leave-it number.
Scheduling and preparation. Once you choose a system, we schedule the installation and explain what to expect, including whether we'll need access to the attic, garage or side yard, and roughly how long cooling will be off.
Installation day. The crew protects floors and work areas, removes the old equipment, sets the new indoor and outdoor units, connects refrigerant lines, wiring and drainage, and makes any planned duct changes. Straightforward replacements often finish in a day; heat pump conversions, ductless systems and major duct work can take longer.
Startup and testing. We check refrigerant charge, airflow, temperature difference across the coil, and electrical readings, and we confirm the thermostat controls the system correctly.
Walkthrough. Before we leave, we show you how to use the thermostat, where the filter is and how often to change it, and what routine maintenance helps the system last. We also clean up the work area and haul away the old equipment.
AC Installation by city
- AC Installation in Inglewood
- AC Installation in Hawthorne
- AC Installation in Gardena
- AC Installation in Huntington Park
- AC Installation in Culver City
- AC Installation in Vernon
- AC Installation in Lawndale
- AC Installation in South Gate
- AC Installation in Lynwood
- AC Installation in Compton
- AC Installation in Maywood
- AC Installation in Cudahy
